Cisco 300-365 ExamWIDEPLOY Deploying Cisco Wireless Enterprise Networks

Total Question: 61 Last Updated: Dec 10,2018
  • Updated 300-365 Dumps
  • Based on Real 300-365 Exams Scenarios
  • Free 300-365 pdf Demo Available
  • Check out our 300-365 Dumps in a new PDF format
  • Instant 300-365 download
  • Guarantee 300-365 success in first attempt
Package Select:

Questions & Answers PDF

Practice Test Software

Practice Test + PDF 30% Discount

Price: $65.95 $29.99

Buy Now Free Trial

Top 10 free samples 300-365 for client (1 to 10)

It is impossible to pass Cisco 300-365 exam without any help in the short term. Come to Actualtests soon and find the most advanced, correct and guaranteed Cisco 300-365 practice questions. You will get a surprising result by our Up to the minute Deploying Cisco Wireless Enterprise Networks practice guides.

Q1. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem? 

A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones. 

B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers. 

C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller. 

D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band. 

Answer:


Q2. What are two functions of the RAP in a mesh network? (Choose two.) 

A. It provides a wired connection for the wireless mesh APs. 

B. It adds capacity and resilience to a mesh area. 

C. it creates a centralized management location for the mesh network. 

D. it reduces the hop count to the wireless network that is connected to the edge. 

E. it routes traffic from the wireless mesh to the wired network. 

Answer: B,D 


Q3. A customer has "quiet" wireless clients that use static IP addresses. Which two WLAN configurations are required for these wireless clients to connect properly? (Choose two.) 

A. Disable DHCP address assignment required. 

B. Enable passive client. 

C. Disable allow AAA override. 

D. Enable static IP tunneling. 

E. Disable DHCP server override. 

Answer: A,E 


Q4. A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped? 

A. 4 

B. 3 

C. 5 

D. 2 

E. 1 

Answer:


Q5. By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead? 

A. 10 Seconds 

B. 60 Seconds 

C. 15 Seconds 

D. 30 Seconds 

Answer:


Q6. A network engineer is debugging issues with the mDNS gateway. Which type of reply should be seen in the Wireshark capture when querying for a mDNS service in the Bonjour Cache? 

A. unicast from Prime Infrastructure 

B. unicast from controller 

C. multicast from devices 

D. multicast from controller 

E. unicast from devices 

F. multicast from Prime Infrastructure 

Answer:


Q7. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller? 

A. 30Seconds 

B. 15 Seconds 

C. 10 Seconds 

D. 60 Seconds 

Answer:


Q8. A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N+1 deployment. Which action must the engineer take to troubleshoot the issue? 

A. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller. 

B. Under the SSID, make sure that 802.1 Iris configured and running for the clients. 

C. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly. 

D. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group. 

Answer:


Q9. An engineer would like to capture NetFlowdata on PI. Which resource is required to allow this? 

A. Cisco MSE as NetFlow exporter 

B. Prime Infrastructure 1.0 or later 

C. Cisco NAC as NetFlow exporter 

D. Cisco ISE as NetFlow exporter 

Answer:


Q10. An engineer used an interface group under the SSID configuration, but noticed that a test client is getting an IP assigned in a different VLAN from the DHCP server. Which two options override the interface group configuration on the SSID? (Choose two.) 

A. static VLAN on client 

B. ACL 

C. AP group 

D. static IP on client 

E. MAC filtering 

F. RF group 

G. AAA override 

Answer: C,G 


Related 300-365 Articles